GET A QUICK QUOTE

Features & Options:

- All shades come with matching fabric insert (exceptions apply)

- NEW automation options available

- NEW Center Support Option

Hardware Colours:

Hardware and components are colour coordinated by default to the fabric selected on your order.If you prefer a custom hardware colour combination, please specify this on your order

Light Gap:

Clutch: 5/8"

Idle End:7/16"

DC Motor: 5/8"

Idle End:7/16"

AC Motor:1"

Idle End:7/16"

Notes:

- Shades over 90� long must be fabricated with S-350 Cassette.

- Please specify ceiling or wall mount installation brackets.

Cassette Fabric Limitations

CENTRE SUPPORT BRACKETS

1) INTERMEDIATE BRACKETS

Link 2 Elite High-Lite� Shades together in one cassette.

Narrower light gap.

Shades operate independently with separate cord or motor controls at the L & R ends of the cassette.

Combined width of both shades cannot exceed 120"

Price As:

Two individual Elite High-Lite� shades.

Light Gap:

Clutches: 3/4"

Middle 3/8"

DC Motor: 3/4"

Middle 3/8"

AC Motor:1"

Middle 3/8"

SHADING SPECIFICATIONS

Width and Length Dimensions:

S-300 Cassette

Min. Width: 12", Max. Width: 90"

Min. Height: 12", Max. Height: 90"

S-350 Cassette

Min. Width: 12", Max. Width: 90"

Min. Height: 12", Max. Height: 120"

Inside Mount (if tight measurements are given):

Cassette will measure ordered width less: �".

Fabric will measure ordered width less 1⅜".

Outside Mount (if finished measurements are given):

Cassette will measure ordered width.

Fabric will measure ordered width less 1â…›".

NOTE ON SPECIFICATIONS

Customer must specify ceiling or wall mount installation brackets on order. The finished dimensions of your shade for both width and height may vary �⅛" from your ordered measurements.

OPERATING CORDS

1) Nylon continuous loop (default option).

2) Plastic bead chain.

Please specify nylon or bead chain controls when placing your order and/or whether exact lengths are required.

MEASURING GUIDELINES

Precise width and height measurements are critical. Please use a metal measuring tape for best accuracy when taking measurements. The headrail must be installed perfectly level and installed evenly to ensure smooth operation. For Inside Mount, it is recommended to check whether the mounting surface is level and consistent. If your soffit needs to be leveled, this should be done before measuring.

Inside Mount

Measure across the width of your window opening in three different places: top, middle and bottom. Measurements should be taken within the window jamb. Provide the smallest of the three measurements to Elite - be exact! Elite will make the necessary deductions to fit the window opening. Measure the length of the window opening from the underside of the soffit to the surface of the window sill in two places; use the smallest of these two measurements.

Outside Mount

Measure the exact width and length of the area to be covered. On the width, allow at least 1�" of an overlap on each side. An overlap of 3" on each side is recommended. Be sure to take into consideration any obstructions such as, moldings, locks, and window cranks.

Alignment

In order to coordinate cassette sizes and ensure uniform fabric alignment, it is critical that you indicate on your order whether shades are to be installed:

- Side-by-side

- In the same room

- With center support option